Preparation of the draft of plastic cards - Plastic cards, ID cards, plastic cards, Qr cards, proximity cards

Plastic cards

Get a free   sample,   order from   1 piece ,  direct   manufacturer

Preparation of cards projects for   Jet -Print  technology

SPECIFICATIONS .

1   Graphic’s size:
•  The project must   have a size of   89x58mm   with not rounded corners   (see figure) . Card ,  after cutting   has a size of   85x54mm   and the   additional   2mm   needed on each side  are a  margin  of  decline .
•  All graphic elements   parallel   to the edge of   the card   should be separated   from   each edge minimum 4mm .  Tolerance   of cards cutter   is   2mm .  Oblonged elements   ( texts,  frames , etc.)  that are parallel   to   the cutting line ,  located   too close to the   edge of the card ,  can be   shifted relative to the   vertical or horizontal axis .  Over   4mm   from the   edge of the card   - the phenomenon   is not noticeable .

2.   File Formats
We prefer   the following   graphic   file formats :
CDR -   max   Corel Draw   X6 .
TIFF   -   RGB,   readable   by   PC
Bitmaps   at min .  300dpi .

3   Additional information

•  If you wish to   print   a barcode,   please   select   on the project   a white   rectangle   where   the code   is to   be found,   but   do not put it   there.
•  In case of   personalization  with  thermal transfer technique   (gold   or   silver)   on the card,   please prepare another project   ( a new one),  in one of   our   preferred   formats , measuring  85x54mm . Please  put   the sample data   for personalization on it   ( where  applicable ),.
•  Do not mark in your design   possible   hole   for a leash   or   tag ,  do it in   demonstrative card drawing , even  in .  jpg
•  Embossed   elements:   like the   hole   for  a  hanger , please  indicate it on   the demonstrative drawing , and  write in your e-mail that these   elements have   to be   convex .  In one line  there  can be   curved  up  to 30 letters   and /   or   numbers ( small font).  All letters   are   capitals   ( upper case  alphabet ).  There are two   font sizes : smaller  ( 4mm-letters and  numbers)   and   bigger ( 5mm - only  numbers).   Embossed subtitles   and   numbers   can be placed   only   in parallel   to the long side  of the  card.

Download Preparation of cards projects for   Jet -Print  technology

Zamów bezpłatną próbkę